Tripp Lite RGB Component Video Over Cat5 Cat6 IP Extender Receiver, TAA

Tripp Lite B160-100-CSI Specifications

Tripp Lite RGB Component Video Over Cat5 Cat6 IP Extender Receiver, TAA

At a Glance

Compatible with Tripp Lite B160-Series A/V over IP transmitters Display video from any source, analog or digital Supports video resolutions up to 1080i Scales up to multi-in, multi-out installation with network switch Plug and play-no software or drivers required

Overview

The B160-100-CSI RGB Component Video + Audio over IP Extender Receiver works with a Tripp Lite B160-Series transmitter (sold separately) to extend and distribute component video + stereo audio, RS-232 serial and IR (infrared) remote signals from the source to the display located up to 328 feet (100 meters) away, which is more than 200 feet farther than a traditional Cat5e/6 solution. By adding a chain of low-cost unmanaged network switches, such as Tripp Lite's NG5, you can continue extending the distance between source and display up to 328 feet per switch. Create a multi-in, multi-out installation with up to 64 transmitters and 255 receivers by connecting dedicated managed Ethernet network switches with Internet Group Management Protocol (IGMP), such as Tripp Lite's NSS-G16D2. With a compatible B160-Series transmitter, this receiver works with any analog or digital source, including HDMI, VGA and DisplayPort™, allowing you to mix and match technologies and use existing source devices. An IGMP-enabled switch will let you manage all connections for centralized control over which sources show on which displays. The B160-100-CSI supports video resolutions up to 1080i. It extends IR control signals that control a source, such as a Blu-ray™ player, from a remote display, as well as RS-232 signals at serial baud rates up to 57600 Bps. It mounts to a wall, rack or pole using the included hardware. Features RGB Component Video + Stereo Audio, Serial and IR Control Signals over Cat5/6 Cabling Receives IP-based audio + video transmitted point-to-point from a source 328 ft. away Add low-cost network switches between transmitter and receiver to continue extending distance up to 328 ft. per switch Create a Multi-In, Multi-Out Installation Using B160-Series Transmitters and Receivers Connect up to 64 transmitters and 255 receivers through multiple dedicated managed network switches IGMP-enabled switches allow centralized control over which sources show on which displays Displays video from any analog or digital source, so you can mix and match technologies and use existing sources and monitors Enhanced Technical Features Supports video resolutions up to 1080i Uses H.264 video compression standard Transmits on 20-60 kHz IR frequency Extends IR control signals that control a source from a remote display Supports RS-232 serial baud rates up to 57600 Bps Plug-and-Play Functionality No software or drivers required Hardware included for mounting on wall, rack or pole Compatible with all Tripp Lite B160-Series A/V over IP transmitters TAA-Compliant Compliant with the Federal Trade Agreements Act (TAA) for GSA Schedule purchases

Package Contents

Receiver Unit External Power Supply (Input: 100-240v, 50/60 hz, 0.5a; Output: 5v 2A) Plug Adapters for U.S., U.K., Europe and Australia IR-In Cable 3.5 mm to db9 Adapter Cable (m/m) Mounting Hardware Owner's Manual

Additional Product Image

See all products