Black Box DB9 A/B Switch

Black Box SW1046A Specifications

DB9 A/B Switch

At a Glance

Switch ports are transparent to data rates, formats, and protocols and can handle speeds up to 10 Mbps. Supports serial remote control and can be switched using commands over a serial RS-232 communications line. supports Ethernet remote control and can be switched using commands sent over an Ethernet network. Manual control of the switch port connection state is supported through pushbutton switches on the front of the unit. The connection state will be maintained if power fails or is removed. Once the Ethernet remote control port has been configured, the A/B Switch can be switched using SNMP commands supports remote telnet access, and can be controlled via a telnet session using the same commands as supported by the RS-232 serial interface

Overview

See all products Durable and reliable. Tested to 1,000,000 cycles Manual control of the switch port supported through A/B push button on the front. Can be switched remotely via Ethernet, RS-232, or dry contact as well.

Certifications & Standards

CE FCC

Miscellaneous

Data Rate Greater than 10 Mbps Power Input: 100-240 VAC, 50-60 Hz, autosensing; Output: 5 VDC Switching Speed Typical: 5 msec; Maximum: 10 msec Connectors: A/B switch ports: (3) DB9 F Ethernet control port: (1) RJ-45 10BASE-T port for remote control interface Serial control port: DB9 F Remote control/status port: (1) 6-position terminal block Power: (1) 2.1 x 5.5-mm power input