Network Cable - Cable Length: 6ft - Compatibility: - Adtran Router - FSU (1200130L1) - Adtran Router - FSU 5622 ESP (1200175L1) - Conductor: Copper - -...

The DSU 56/64 provides both a physical and electrical V.35 DTE interface, which is mounted on the rear panel. The DTE interface operates at the same rate as the network, either 56 or 64 kbps. Also located on the rear panel is a set of option DIP switches along with an RJ-48S network interface. The option switches allow the user to select the Network/DTE data rate, control lead options, remote digital loopback, and scrambler options....

The DSU 5600 provides both a physical and electrical EIA-232 DTE interface, which is mounted on the rear panel. The network interface operates at either 56 or 64 kbps. The DTE interface operates either at 56 or 64 kbps synchronous or 1.2 to 57.6 kbps asynchronous. Also located on the rear panel are option switches along with an RJ-48S network interface....

The ADTRAN DSU III AR is a technologically advanced, high performance data service unit/channel service unit (DSU/CSU). This unit provides a reliable interface between the digital data service (DDS) or 4-wire Switched 56 (SW56) network and the customer's data terminal equipment (DTE). The unit is an...

The ADTRAN DSU III AR is a technologically advanced, high performance data service unit/channel service unit (DSU/CSU). This unit provides a reliable interface between the digital data service (DDS) or 4-wire Switched 56 (SW56) network and the customer s data terminal equipment (DTE). The unit is an...

The ADTRAN DSU IV ESP is an all-rate data service/channel service unit (DSU/CSU) with an integral SNMP (simple network management protocol) agent and optional dial backup (DBU) capabilities....

The DSX-1 module expands the capability of your TSUs product by providing a DSX-1 interface. This module should be selected when a standard DSX-1 interface is required, such as a connection to a PBX. - The DSX-1 Module is part of a family of nearly 30 application- specific modules available for the TSU series designed to accommodate almost every combination of voice, video, data, and Internet applications over a TDM T1 circuit....

The 2FXO module is one of several expansion modules for the TSU Multiplexer family. This module should be selected when a connection to one or two voice line cards of a key system or PBX is required. PBX extensions may be extended to a remote site by combining a TSU on the remote end with FXS modules....

FXS module provide a quick and simple upgrade path for TSU multiplexers requiring support for PBX's, KSU's, analog telephones, dial-up modem pools, fax machines and leased line modems. - For applications involving message waiting or the requirement for more robust ringing voltage, the FXS+ (MW) module is available....

The ADTRAN Dual DSU III provides a reliable, high speed data connection for customer data terminal equipment (DTE) through the ADTRAN TSU/HSU DS0 port. It provides compatibility with digital data service (DDS), or Switched 56 network (SW56) services. The Dual DSU III supports both synchronous and asynchronous data communication over the DDS or Switched 56 networks....

The ADTRAN Dual DSU III provides a reliable, high speed data connection for customer data terminal equipment (DTE) through the ADTRAN TSU/HSU DS0 port. It provides compatibility with digital data service (DDS), or Switched 56 network (SW56) services. The Dual DSU III supports both synchronous and asynchronous data communication over the DDS or Switched 56 networks....

E&M module provide a quick and simple upgrade path for TSU multiplexers requiring support for PBX's, KSU's, analog telephones, dial-up modem pools, fax machines and leased line modems. - Applications involving 2- or 4-wire E&M tie lines are supported in the TSU multiplexer with the E&M module. In addition to supporting Type I, II and V E&M signalling, the E&M module support legacy leased line modems in Transmit Only (TO) mode....

E&M module provide a quick and simple upgrade path for TSU multiplexers requiring support for PBX's, KSU's, analog telephones, dial-up modem pools, fax machines and leased line modems. - Applications involving 2- or 4-wire E&M tie lines are supported in the TSU multiplexer with the E&M module. In addition to supporting Type I, II and V E&M signalling, the E&M module support legacy leased line modems in Transmit Only (TO) mode....

When density is an issue in your TSU multiplexer installation, the Dual Nx56/64 Plug-in Module should be used. Providing two miniature DB-26 interfaces, this module uses adapter cables to provide a female V.35 Winchester interface. - The Dual Nx56/64 Module provides two standard synchronous data interfaces suitable for most high speed data applications....

The ADTRAN Dual OCU DP Module is an expansion module for the TSU Multiplexer Family. Designed to provide full OCU DP operation for office applications, the module can be used to extend 64k DDS, Switched 56 or Frame Relay circuits up to 18,000 feet from the multiplexer. The Dual OCU DP Expansion module...

The ADTRAN Dual OCU DP Module is an expansion module for the TSU Multiplexer Family. Designed to provide full OCU DP operation for office applications, the module can be used to extend 64k DDS, Switched 56 or Frame Relay circuits up to 18,000 feet from the multiplexer. The Dual OCU DP Plug-On module...

The ADTRAN T1 ESF CSU is a full-featured T1 Channel Service Unit used to connect T1 data terminal equipment (DTE) such as a PBX, switch or channel bank to T1 facilities. Capable of interfacing to both B8ZS or AMI circuits, the T1 ESF CSU can convert signal formats or line code to integrate older equipment....

CSU/DSU Module - Data Transfer Rate: 75Kbps to 44.2Mbps - Ports: 1 x 50-pin SCSI-2 Serial - Form Factor: Plug-in Module - Additional Information: - Installs in T3SU 300 and OSU 300 units - Data Link Protocol: HSSI - Standard Warranty: 5 Year - -...

The ADTRAN ESU LT is a low-cost, fullfeatured E1/FE1 data service unit/channel service unit (DSU/CSU). The ESU LT provides an interface between E1 or Fractional E1 service and the end user's data terminal equipment (DTE) for applications such as LAN-to-LAN bridging, Frame Relay circuit termination, and video-conferencing....