Viking Electronics Multi Imput Voice Alarm Dialer

Viking Electronics K-2000-DVA Specifications

Multi Imput Voice Alarm Dialer

Overview

Viking's K-2000-DVA is a fully programmable multi-input, multinumber auto dialer and digital announcer, designed for emergency and non-emergency message notification. The K-2000- DVA has eight dry contact inputs, each of which can dial up to eight 32-digit phone numbers and play a message up to 1 minute in length specific to that input. Viking's K-2000-DVA is a fully programmable multi-input, multinumber auto dialer and digital announcer, designed for emergency and non-emergency ication message notification. The K-2000-DVA has eight dry contact inputs which when tripped will sequentially dial up to 8 different phone numbers and play a recorded message corresponding to the input tripped. The K-2000-DVA can store up to seven 16 digit phone numbers and one 32 digit phone number (for use with pagers) per input for a total of up to 64 different numbers. This unit is capable of local or remote recording of up to 8 different messages (one message per input), with a total recording time of one minute. The K-2000-DVA can also be configured as a store caster (no dialing), for on-site promotional or assistance announcements.

Compatibility

See all products Remote DTMF Controllers: RC-2A RC-3 Viking DTMF Controllers: RC-2A RC-3

Application/Usage

Security Fire Alarm Automatic Telephone Messaging Paging Enviromental Warning Alarm Dialer

Miscellaneous

Non-volatile memory (no batteries required) Stores up to eight 32-digit numbers (sixty four 32-digit numbers total) 8 minutes of record time (1 minute per input) Programmable message repeat counter Programmable lap counter Eight inputs programmable as normally open or normally closed and enabled or disabled Programmable ring delay for remote programming and alarm polling Programmable qualifier timer for each input (time for an event to be qualified as an alarm) Programmable resume timer for each input (time following reset for input to become active again) Call progress detection Programmable ringback limit for call progress Remote security and access codes Store caster mode Local or remote programming and recording RS-232 port for programming via a PC Compatible with the RC-2A and RC-3 remote DTMF controllers Security/burglar/ fire alarm notification Features Non-volatile memory (no batteries required) Stores up to (7) 16-digit numbers and (1) 32 digit phone number per input (64 total) 60 total seconds of record time Programmable message repeat counter Programmable lap counter for dialing groups of phone numbers Eight programmable normally open/closed inputs Programmable ring delay for remote programming and alarm polling Pager compatible Remote security and access codes Programmable store caster mode CPC break detection Local or remote programming and recording RS-232 port for programming via a P.C. Compatible with the RC-2A and RC-3 remote DTMF controllers Specifications Power: 120V AC/12V DC 500 mA, UL listed adapter provided Environmental: 0°C to 32°C (32°F to 90°F) with 5% to 95% noncondensing humidity Talk Battery: 13V DC Touch Tone Dialing: 120 ms on/off CPC Detection Time: 320 ms minimum Message Record Time: 60 seconds Sampling Rate: 64 K (equivalent) Momentary Trigger Input: 100 ms minimum normally open/normally closed Connections: (2) RJ11 jacks for 600-ohm audio output and telephone line/phone, (1) 9 pin RS-232, (1) 12 position screw terminal block for dry contact trigger inputs