HomeIndexesManufacturerGroupNM-1T3/E3=

Cisco Systems 1-Port T3/E3 Network Module

Cisco Systems NM-1T3/E3=

Cisco Systems

Manufacturer Part#  NM-1T3/E3=

UPC Code: 746320697710

Provantage Code:  CSCR26C

  • Product Type: Switching Module
  • Maximum Data Transfer Rate: 44.74 Mbps
  • Application/Usage: Switching Network
  • Network Technology: T3/E3

100% Satisfaction Guaranteed

Note: We Are Unable to Sell this Product to Dealers.
Provantage is authorized to only sell this product to a final purchaser or licensee that has acquired it for their own use and not for resale, remarketing or distribution.

NetworkingRouting and Switching DevicesModules

Cisco Systems NM-1T3/E3= Specifications

    1-Port T3/E3 Network Module


Overview

    This product is NIB, Factory Sealed, and Guaranteed Authentic.

    The Cisco T3/E3 Network Module provides high-speed WAN access for the Cisco 2600, 3600, and 3700 series routers. T3/E3 WAN access enables the network to carry high volumes of data and rich multimedia content, while providing low latency for voice over IP (VoIP).

    The Cisco T3/E3 Network Module provides high-speed WAN access for the Cisco 2600, 3600, and 3700 series routers. T3/E3 WAN access enables the network to carry high volumes of data and rich multimedia content, while providing low latency for voice over IP (VoIP).

Specifications

General Information
Product Name1-Port T3/E3 Network Module
Manufacturer Part NumberNM-1T3/E3=
Product TypeSwitching Module
Technical Information
Application / UsageSwitching Network
Interfaces/Ports
Interfaces / Ports Details1 x BNC Female T3/E3 Network Full-duplex WAN
Media & Performance
Media Type SupportedCoaxial
Network TechnologyT3/E3
Maximum Data Transfer Rate44.74 Mbps
Physical Characteristics
Height1.6"
Width7.1"
Depth7.2"
Warranty
Limited Warranty90 Day
Other Information
Data Transfer Rate5.59 MBps

4.30 MBps

CompatibilitySupported Platforms & Minimum IOS Versions:
  • 3745 - 12.2(11)YT
  • 3725 - 12.2(11)YT
  • 3660 series - 12.2(11)YT
  • 3640 - Not Available
  • 3620 - Not Available
  • 2691 - 12.2(11)YT
  • 2650 - Not Available
  • 2600XM Series - 12.2(11)YT
  • 2600 series - Not Available
  • 1720 - Not Available
  • 1600 series - Not Available

Supported Platforms & Minimum IOS Versions:

  • 3745 - 12.2(11)YT
  • 3725 - 12.2(11)YT
  • 3660 series - 12.2(11)YT
  • 3640 - Not Available
  • 3620 - Not Available
  • 2691 - 12.2(11)YT
  • 2650 - Not Available
  • 2600XM Series - 12.2(11)YT
  • 2600 series - Not Available
  • 1720 - Not Available
  • 1600 series - Not Available
Additional Information
  • DSX3 level interface with dual female 75-ohm BNC coaxial connectors per port (separate RX and TX)
  • Scrambling and subrate support of major DSU vendors
  • Line build-out - Programmable for up to 450 feet of 734A or equivalent coaxial cable or up to 225 feet for 728A or equivalent coaxial cable
  • C-bit, or M23 framing for T3, bypass and G.751 framing for E3 (software selectable)
  • Binary 3-zero substitution (B3ZS) (T3) or high-density bipolar with three zeros (HDB3) (E3) line coding
  • Support for 16- and 32-bit CRC (16-bit default)
  • DS3 FEAC channel support
  • Twenty-four-hour history maintained for error statistics and failure counts
  • DS3 alarm and event detection (once per second polling)
  • Alarm indication signal (AIS)
  • Out of frame (OOF)
  • Line code violation (LCV)
  • Excessive zeros (EXZ)
  • Far-end receive failure (FERF)
  • Line and payload loopback capabilities
  • DS3 remote-line loopback (via Far End Alarm and Control [FEAC] codes per American National Standards Institute [ANSI] T1.107a)
  • Response to embedded loopback commands
  • Insertion of loopback commands into transmitted signal
  • Programmable pseudorandom pattern up to 32 bits long, including 223, 220, 215, 1s, 0s, alt-0-1
  • 32-bit error count and bit-count registers
  • Alarm detection - Alarm indication signal (AIS), remote alarm, far-end block error (FEBE), out of frame (OOF)
  • Onboard processor for Maintenance Data Link (MDL)
  • Physical space savings - Eliminates the need for external DSU device, saving valuable rack space
  • Software- configurable T3/E3 - Provides the flexibility to deploy a single module worldwide

    Serial Encapsulations:
  • HDLC
  • PPP
  • Frame Relay
  • ATM Data Exchange Interface (ATM-DXI)
The Following Are Compatible With Cisco Systems NM-1T3/E3=

Cisco Systems 3925 with SPE1003GE 4EHWIC4-DSP 2SM 256MBCF 1GB DRAM

Mfg Part# CISCO3925/K9


Cisco Systems 3945 SPE150 3GE 4EHWIC-4SM 256MBCF 1GB DRAM IPB

Mfg Part# CISCO3945/K9


Cisco Systems 3925 Security Bundle with Security License

Mfg Part# CISCO3925-SEC/K9


Cisco Systems 3945 with SPE250 4GE 3EHWIC-3DSP 4SM 256MB CF 1GB

Mfg Part# CISCO3945E/K9


Cisco Systems 3945 Security Bundle with Security License

Mfg Part# CISCO3945-SEC/K9


Considering a Volume Purchase?
You may be able to save even more on your order if you meet the following Cisco Systems BIG DEAL qualifications:

Purchase at least $20,000 of Cisco products to qualify.


Shop with confidence! Provantage is an authorized Cisco Systems dealer.

Visit the Manufacturer
Learn more by visiting the manufacturer's website.

Cisco Systems
 
© Copyright 1984-2015 Provantage
Cisco Systems NM-1T3/E3=